Fuel Stabilizer

Lucas Oil Products, Inc.

Fuel Stabilizer

A better solution to prevent gasoline break-down during storage. Safe to use in all grades of gasoline and in all 2 and 4 cycle engines. Easy to use! Application rate, 1oz. to treat 1 gallon.

 

Key Benefits

  • A better solution to prevent gasoline break-down during storage
  • Safe to use in all grades of gasoline and in all 2 and 4 cycle engines
  • Easy to use! Application rate, 1oz. to treat 1 gallon

 

Packaging

  • #20314 - 8 Ounces (Case of 12) - 237 mL
  • #20302 - 15 Ounces (Case of 12) - 444 mL
  • #20303 - 1 Quart (Case of 12) - 946 mL
  • #10324 - 5 GALLON (Case of 1) - 18.9 L
  • #10326 - 55 GALLON (1 Drum) - 4208.2 L

 

Documentation

Technical Data Sheet Technical Data Sheet
Safety Data Sheet Safety Data Sheet

Click here to get Adobe Reader

Greg V from K&N Engineering is glad to use Lucas Oil 20W-50 Racing Blend in his oil pan!

Hey guys and gals.

I just wanted to drop you a quick note to let you folks know how glad I am that I have Lucas Oil in my oil pan…

On Friday night at Pomona, I was truckin’ on down the track 1st round… I got the winlight, and after I passed the winlight I noticed that I had absolutely 0 oil pressure. As soon as I possibly could, I grabbed neutral, and clicked the engine off. I coasted around the corner, and came to a stop. I thought maybe my oil pump pick-up tube came off, but after I got back to my pit area, and further inspecting the situation, I realized that it could quite possibly be much worse. After pulling the distributor out, I found that the oil pump drive was missing, which tells me that the oil pump is laying in the oil pan. With 2nd round 30 minutes after the 1st round, I didn’t have time to see about getting it fixed for the next round. So I was a no-show 2nd round. It was too bad, because I was .008 on the tree & 9.914 on the track, and feeling pretty confident.

On Sunday morning, I pulled the oil pan off, and sure enough, I found the oil pump & pick-up laying in the oil pan. It appears that the oil pump just sheared off the rear main cap. So I began looking at the rod bearings, and I think I got extremely lucky, as I pulled down 4 rod caps, and eventhough the bearings were starting to get ugly, the crank looks flawless, thus far. Looks like the top layer of the bearings took a beating. I hope the crank passes magnaflux, otherwise, it’s only going to cost me a set of bearings & possibly some other minor cost. The rods never got hot or blue in color. I’m hoping for the best. I was using the 20W-50 Racing Blend with a quart of oil stabilizer. Thank the lord above I did so. You may use this as a testimonial.  It saved me from having extensive engine damage.

[img]4592|center|||no_popup[/img]


Thanks for the great products!

Greg Ventura
Material Lifecycle Analyst
K&N Engineering, Inc.
Riverside, CA  92507

 

Share Your Lucas Oil Story